AutoChips 3-in-1 Automotive Software Pack

The AutoChips 3-in-1 Automotive Software Pack gives you three diagnostic and programming tools in one suite. You get support for ECU editing, EEPROM functions, and diagnostics. You work faster because each tool loads inside one menu with no separate installations. This helps you reduce steps during repair work and shortens your workflow.

The software supports a wide range of ECUs from brands like Toyota, Lexus, Honda, Nissan, Hyundai, Kia, Ford, GM, BMW, Mercedes, VAG, Peugeot, Renault, Fiat, and others. You handle checksum fixes, VIN edits, coding tasks, DTC clearing, and small calibration edits. You work with OBD files, bench files, and BDM reads.

You get a stable EEPROM editor for reading, writing, and hex level editing. This supports 24Cxx, 93Cxx, 95xxx, and MCU based dumps. You use it for odometer jobs, immobilizer records, key ID blocks, configuration bytes, and module repair work.

The ECU module supports IMMO solutions, file correction tasks, DPF OFF, EGR OFF, AdBlue OFF, speed limiter edits, torque limiter edits, oxygen sensor edits, and checksum auto fixing. You load bin files and get processed output in direct format ready for flashing.

The diagnostics module reads fault codes, clears fault codes, reads live data, tests actuators, and performs basic coding functions. This helps you check a module before and after repair. You also verify your edits with live readings.

The software supports common interfaces including J2534 devices, ELM327, and several pass-thru adapters. You run the suite on Windows 7, Windows 8, Windows 10, and Windows 11. Installation is simple because the pack is already pre configured.

Workshops use this pack to handle mixed tasks like DPF repairs, failed ECU modules, lost sync IMMO issues, odometer corrections, and sensor related faults. You also get ready access to basic calibrations and EEPROM tools in one place.

Main Features

• ECU correction tools for DTC, DPF OFF, EGR OFF, AdBlue OFF, IMMO tasks, and checksum fixes.
• EEPROM editor for 24Cxx, 93Cxx, 95xxx and MCU files.
• Diagnostics module for reading codes, clearing codes, live data, and actuator tests.
• Support for OBD files, bench files, and BDM reads.
• Works with J2534 and ELM327 tools.
• Windows 7 to Windows 11 support.
• Fast menu structure with three tools in one interface.

Typical Use Cases

• ECU repair after failed flash.
• IMMO record editing through EEPROM dump.
• DPF or EGR related repair tasks.
• Sensor DTC removal after hardware replacement.
• VIN correction during module swap.
• Speed limiter and torque map adjustments.
• Pre and post repair diagnostics checks.

Included Modules

• ECU File Editor.
• EEPROM Manager.
• Diagnostic Reader.

System Requirements

• Windows 7, 8, 10, or 11.
• 4 GB RAM or higher.
• J2534 or ELM327 device for diagnostics and OBD tasks.

Contact

For purchase and support, visit jaybeeautos.com or chat via WhatsApp at +48732100572